PAPER-
7 sheets Stamper's Select White cut in half lengthwise at 4 1/4
13 sheets Silver Shimmer Card Stock cut in half lengthwise at 4 1/4 and then scored at 5.5". (KEEP the scraps. You will be using this paper to make your punches.)
25 6 inch pieces of Silver Tinsel Ribbon
OTHER-
Nestability Dies: Largest Scalloped Circle Die along with the second to largest scalloped circle die
1/2 inch circle punch, 1/4 inch circle punchTag Punch (stampin up!) OR a strip of paper cut to1"x2" and then scored at the midway point.Pinking Shears to cut the bottom for the decorative edge
fine glitter
Copic Markers
Mono Multi Glue
CUTTING: 13 sheets Silver Shimmer Card Stock cut in half lengthwise at 4 1/4 and then scored at 5.5" and using the largest scalloped circle nestability die, run through the cuttlebug several times (I do 5) keeping an exposed piece at the top so it does not cut all the way through. (KEEP the scraps. You will be using this paper to make your punches.) 7 sheets Stamper's Select White Card Stock cut in half lengthwise at 4 1/4 and you will have enough room on each strip to cut two dies using the second to largest scalloped circle nestability die.
Use silver scrap paper to punch using your 1/4 inch punch, then lining up the 1/2 in punch around the punch you just made to create the circle for the ribbon to go through at the top of the ornament. Use the tag punch and punch 25 times on the silver card stcok. Take pinking shears and trim the bottoms.
